Sunvisor Replacement
| 1. |
After loosening the mounting screws, then
remove the sunvisor (A) and retainer (B).
|
| 2. |
Installation is the reverse of
removal. |
Assist Handle Replacement
| 1. |
Remove the covers (A), and remove the screws,
then remove the assist handle (B).
|
| 2. |
Installation is the reverse of
removal. |
Overhead Console Replacement
| 1. |
After loosening the mounting screws, then
remove the overhead console assembly (A).
|
| 2. |
Push the lock pin (A), disconnect the
connectors (B).
|
| 3. |
Installation is the reverse of
removal.
| •
|
Make sure the connector is plugged
in
properly. | | |
Room Lamp Replacement
| 1. |
Using a screwdriver, remove the cover
(A). |
| 2. |
After loosening the mounting screws, then
remove the room lamp (B). |
| 3. |
Disconnect the connector (C).
|
| 4. |
Installation is the reverse of
removal.
| •
|
Make sure the connector is plugged
in
properly. | | |
Vanity Lamp Replacement
| 1. |
Using a screwdriver, remove the vanity lamp
(A). |
| 2. |
Disconnect the connector (B).
|
| 3. |
Installation is the reverse of
removal. |
Roof Trim Assembly Replacement
| •
|
Put on gloves to protect your
hands. |
| •
|
When prying with a flat-tip screwdriver,
wrap it with protective tape to prevent
damage. |
| •
|
Take care not to bend or scratch the
trim and
panels. | |
| 1. |
Remove the following items.
|
| 2. |
Disconnect the cover (A) and ECM room mirror
connector (B).
|
| 3. |
Disconnect the cover (A) and rain sensor
connector (B).
|
| 4. |
Disconnect the wiring connector (A), mounting
clips.
[Driver's]
[Passenger's]
|
| 5. |
Disconnect the antenna connector
(A).
|
| 6. |
Disconnect the connector
(B). |
| 7. |
Disconnect the clips and then remove the roof
trim (A).
|
| 8. |
Installation is the reverse of
removal.
| •
|
Replace any damage
clips. | | |
